# It is intended mainly as a brake to keep a runaway server from taking # the system with it as it spirals down... # MaxClients 150 # # MaxRequestsPerChild: the number of requests each child process is # allowed to process before the child dies.   The child will exit so # as to avoid problems after prolonged use when Apache (and maybe the # libraries it uses) leak memory or other resources.   On most systems, this # isn’t really needed, but a few (such as Solaris) do have notable leaks # in the libraries. For these platforms, set to something like 10000 # or so; a setting of 0 means unlimited. # # NOTE: This value does not include keepalive requests after the initial # request per connection. For example, if a child process handles # an initial request and 10 subsequent "keptalive" requests, it # would only count as 1 request towards this limit. # MaxRequestsPerChild 100000 # # Listen: Allows you to bind Apache to specific IP addresses and/or # ports, in addition to the default. See also the <VirtualHost> # directive. # #Listen 3000 #Listen 12.34.56.78:80 # # BindAddress: You can support virtual hosts with this option. This directive # is used to tell the server which IP address to listen to. It can either # contain "*", an IP address, or a fully qualified Internet domain name. # See also the <VirtualHost> and Listen directives. # #BindAddress * # # Dynamic Shared Object (DSO) Support # # To be able to use the functionality of a module which was built as a DSO you # have to place corresponding ‘LoadModule’ lines at this location so the # directives contained in it are actually available _before_ they are used. # Please read the file README.DSO in the Apache 1.3 distribution for more # details about the DSO mechanism and run ‘httpd -l’ for the list of already # built-in (statically linked and thus always available) modules in your httpd # binary. # # Note: The order in which modules are loaded is important.   Don’t change # the order below without expert advice. # # Example: 30